Two component polyester filler containing specially cut glass fiber
which increases mechanical resistance of the product. Advisable for
filling hollows and reinforcing the areas weakened by corrosion or rust.
It has very good filling properties and good adhesion to the surface.
Polyester filler MICRO GLASS is reinforced with glass fiber. Thanks to
the use of elastic polyester resins and short fiber glass it is much
more flexible than the filler GLAS, having at the same time high
mechanical resistance. As it is fast and easy to process, it can be used
even on large ..
This product is designed for filling smaller or bigger irregularities and hollows before the application of a primer. Putty 3 in 1 provides reinforcement, filling and finishing. Contains optimal quantity of glass fibres responsible for the effect of reinforcement, and differentiated granulation guar..
Unsaturated polyester resin containing special catalysts is designed for
hand lamination. It is ideal for the repair of large rusty areas of car
bodies and laminates. It can be used for the repair of caravans, boats,
yachts, etc. Hardened coat is marked by good adhesion to the surface
Spray filler is designed for filling scratches resulting from processing previously applied filler coats. To be applied by air spraying. Thanks to good thixotropy it does not flow down and it can be applied in relatively thick layers even on large vertical surfaces. It is marked by good filling prop..
It is a mixture of adequate thinners which results in a product with
definite evaporation times. Designed for thinning spray putty UNI-SPRAY,
polyester resin and, if necessary, other polyester putties RANAL.
Ensures proper application and drying of the thinned product...
UNI filler is designed for filling unevenness and hollows of the surface
before applying a top coat. It is characterized by fine-grained
consistency and not very high flexibility. Fairly hard, it results in
coats of good adhesion to undercoated and plain surfaces. It is
recommended for mecha..
Designed for protecting joints of car body and chassis. It is a one component, quick drying product. It cures in reaction with moisture contained in the air. The cured coat is characterized by high flexibility and good adhesion to the substrate. It does not shrink or crack, and has high resistance t..
REMOVER gel is a product which allows efficient and effective removing
of old paint coats from various substrates. It's most important
characteristic is it's gel formula, thanks to which it does not stream
down and allows the application on vertical surfaces.Additional information Product..
This box, containing glass mat, polyester resin and hardener, is designed for filling the losses and strengthening rusty areas in car bodies, boats, yachts and caravans. It has a very good adhesion to the surface. After hardening it results in a very hard surface suitable for filling. Hardened coat ..
Product in aerosol based on phenolic resins and mineral fillers, designed for protecting car chassis against corrosive and erosive effects of weather conditions. Unlike ANTIGRAVITEX protecting agent it cannot be coated...